07-128.2K Stage 2 Kevlar Clutch Kit: Ford Bronco, F150 F250 F350 Pickup - 11 in.

This is a Phoenix Friction Stage 2 Kevlar Street Performance Clutch Kit. The kit features an original stock pressure plate and a Phoenix Friction high heat Kevlar spring dampened disc. This Kevlar clutch guarantees a chatter free engagement, and is without a doubt the smoothest engaging clutch on the market today. It will provide up to a 20% increase in engine torque capacity over the OE clutch. At the same time, you will not notice any increase in pedal effort over the stock clutch. Since there are no metal or abrasive particles in the friction material, Kevlar significantly reduces flywheel wear, and provides 300% longer life than that of original equipment under normal driving conditions. Note: Kevlar is a high tech material that needs up to a 1000 mile break in period to properly seat for optimum performance.

A Phoenix Stage 2 Kevlar product is a direct factory fit and requires no modifications for installation.

We highly recommend replacing the internal concentric slave cylinder at the same time you are replacing the clutch kit.  See our part number CSC003.

Features:

1. We use only quality clutch components that are engineered to function as a matched set and work the way they should with the rest of the driveline components
2. Our kits contain all new components
3. They have been designed to be a direct replacement for the original equipment components used when the vehicle is new
4. All the components we use are manufactured and tested to the Original Equipment specifications of the major automobile manufacturers
5. We warrant that all products are free from defects in workmanship and materials
6. Expert toll-free technical assistance is available

Other available clutch kits for this vehicle:

07-128           Organic, Engine Torque Capacity = 365 lb.ft., 295HP
07-128.3C      Ceramic, Engine Torque Capacity = 515 lb.ft., 410HP

Clutch Specifications:

Friction Material: Disc Size: Disc Type: Release Type:	Kevlar 11" x 10T x 1-1/16" Dampened Push
Kit Includes:  Pressure Plate, Clutch Disc, Release Bearing, Pilot Bearing, Alignment Tool
Engine Torque = 460 lb-ft., 370HP

Refer to the technical bulletin TB015 regarding Clutch Chatter caused by Improper Driveshaft Angle.

Refer to the technical bulletin TB033 regarding possible Hard Pedal or Release problem due to leaking slave cylinder seal.

Technical Bulletins are shown to provide you with additional information that may affect the installation of this clutch part in your vehicle. The bulletin does not indicate that the part you are looking to purchase is compromised in any way. These bulletins are often generated by the original vehicle manufacturer or the original clutch manufacturer and are intended to make the installer aware of issues that may affect the performance of the clutch system.

There are no comments for this product.

Fits: